My engine let go last year and I've now rebuilt it all with an STi 8 bottom end and my STi5 heads. Its all built up and in the car with most stuff connected. Its been that long since I took everything off I can't remember where everything goes. Its all the vac pipes and the pipes that go to the carbon canister that I'm struggling with. Ideally I'd like to remove the carbon cannister and all the pipes if that's possible as It would make a bit more space (Its only for emissions anyway isn't it?) so which pipes do I blank off and where would they go to normally?. The car is also fitted with an AVCR boost controller that I think is plumbed in right. NO to compressor housing and COM to actuator. Which pipes do I connect to the 3 little pipes sticking out of the inlet? 1 is for the dump valve but what are the other 2 for?

Also there is this on the back of the inlet that the black connector plugs on to, where do the 2 pipes go to?



Where do the earth wires fro the battery run to aswell?

Any help on this would be greatly appreciated