troble with my rebuild
#1
troble with my rebuild
Hi people iv had my buy eye sti engine rebuilt and would like to know best way to run it in and it almost done 450miles from its rebuild and iv got a knockin coming from the engine bay its not a loud knocking more when i start her up
help
phill
help
phill
#2
Hi Phill the knocking is not a good sign mate. Did you buy the engine or build it yourself? As a rebuild the mains and big ends should have been done so maybe piston slap??Is it centrally or left/right bank? I run mine in 500 miles on classic oil trying to stay under 3,000 revs the dump oil and run as per usual on usual grade.
Spen
Spen
#3
had it rebuilt got a 12000 miels wranty on it . iv been runnin it about 3,000 to 3,500 going back at 500 for an oil change im runnin it on 5w - 30 semi semfict not sure were its coming from not to good with car engines
Trending Topics
#8
Had it done by an engine rebuild company and it had lots done new crank new pistons etc so i hope its just a bit of noise nothink more but when i got the car it was only on 3 cylinds not 4 so had to have it rebuilt .
whats the best oil to use & want to strat moding when its runnin where is best to start
whats the best oil to use & want to strat moding when its runnin where is best to start
#9
Had it done by an engine rebuild company and it had lots done new crank new pistons etc so i hope its just a bit of noise nothink more but when i got the car it was only on 3 cylinds not 4 so had to have it rebuilt .
whats the best oil to use & want to strat moding when its runnin where is best to start
whats the best oil to use & want to strat moding when its runnin where is best to start
it wasn't SMR or ideal engines was it?
#12
I tend to run in as :
3000-3500 rpm and little / no boost for 500 miles.
Increase revs by 500 each further 100 miles, so at 700 miles can use 4500 rpm, 6000 rpm at 1000 miles and some boost .... i.e. stay in I mode.
Use mineral oil for running in for first 500 or so miles, semi synth for next 5000ish, then good fully synth there after.
I'd change oil more often then the 10,000 miles Subaru say.
3000-3500 rpm and little / no boost for 500 miles.
Increase revs by 500 each further 100 miles, so at 700 miles can use 4500 rpm, 6000 rpm at 1000 miles and some boost .... i.e. stay in I mode.
Use mineral oil for running in for first 500 or so miles, semi synth for next 5000ish, then good fully synth there after.
I'd change oil more often then the 10,000 miles Subaru say.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM