hi all been an eventfull day or so last night i did the following
done a parallel fuel mod
fitted my 440cc

other than a few issues with the above inj leaking and sucking air in

when i went on a test run i did heavy brake with no dramas but when i parked up turned off then came back while later abs light on
done a battery off reset also a hard reset and still on any ideas ???????

 

the two front roadwheel abs harnesses connect under bonnet,follow both fronts up the abs wires from the inner arches and where they pass through the inner wings they then connect via plugs ,suggest check to see if one has accidentally come apart or have been disturbed bud ???

 

can't clear the code until you fix the problem

 

how do u bring the codes up ?

 

select monitor!

 

cool you have or have have access to one

 

a what

 

diagnostics device,subaru select monitor,nine pin connector ,plugs in rh side of centre console on my 98 uk but i think older versions had connector taped above green/black connectors under steering column

 

http://codes.rennacs.com/ABS-Brakes/...Subaru-ABS.php

 

If you look under the dash you should find a black connector, taped to it should be a single wire - you might have to do a bit of searching to find it. Plug this into hole 6 of the connector then switch the ignition on. The ABS light should flash the error code, if I remember correctly the longer flashes are tens, short units. It will flash 11 first - long flash, short flash, followed by the error codes:

ABS DTC list

11 – Start Code, DTC is shown after start code, Only start code is shown in normal condition

Abnormal ABS sensor, open circuit or voltage too high
21 – front right ABS sensor
23 – front left ABS sensor
25 – rear right ABS sensor
27 – rear left ABS sensor

Abnormal ABS sensor, abnormal ABS sensor signal
22 – front right ABS sensor
24 – front left ABS sensor
26 – rear right ABS sensor
28 – rear left ABS sensor
29 – any one of four

Abnormal solenoid valve circuits in ABS control module and hydraulic unit
31 – Front right inlet valve
32 – Front right outlet valve
33 – Front left inlet valve
34 – Front left outlet valve
35 – Rear right inlet valve
36 – Rear right outlet valve
37 – Rear left inlet valve
38 – Rear left outlet valve

41 – Abnormal ABS control module
42 – Source voltage is abnormal
44 – A combination of AT control abnormal
51 – Abnormal valve relay
52 – Abnormal motor and/or motor relay
54 – Abnormal stop light switch
56 – Abnormal G sensor output voltage

 

have access to one

 

does any one have piccys ?

 

right heres a follow up
checks all abs sensors all showing 1.13k res
checks all fuses all ok
checked all wire by pump all ok
found yellow plug and the two fly leads for diagnosis, tryed to get code but abs light wont flash i put it into the bottom right most space 6


any ideas as i am out of ideas