Hi, ive installed a innovate wideband kit in place of my faulty narrowband sensor and am feeding the simulated output to the ecu. I took this route as i have a v6 and wanted to make sure open loop fuelling was on the rich side and maf was healthy. I can live with service life of wideband sensor.

I am going to adjust the narrow band output as the voltages are slightly higher than what i believe the stock sensor outputs ranging from 0.3 to 1.2 volts. I believe stock should swing from 0v to 0.9v with a mean of about 0.45v. Is this correct?

Ive done a search but there doesnt seem to be much info on rough settings for the adjustment values. I have the programming software just looking for any info before i have a tinker later on.

Thanks.