Headers/egt fitting help please
05 May 2011, 06:47 PM
#1
Headers/egt fitting help please
Hi,
Ok i managed to pick up some brand new RCM headers with up pipe for £335 so over the moon there but I'm having a few problems with refitting my EGT sensor..
As you can in the pic below its the reason I'm having to replace the headers as it snapped out of the old up-pipe.
Does anyone know where i can either get a new bung from or a way of fitting it to the lambda hole in the up-pipe..I'm a little stuck really.
Ok i managed to pick up some brand new RCM headers with up pipe for £335 so over the moon there but I'm having a few problems with refitting my EGT sensor..
As you can in the pic below its the reason I'm having to replace the headers as it snapped out of the old up-pipe.
Does anyone know where i can either get a new bung from or a way of fitting it to the lambda hole in the up-pipe..I'm a little stuck really.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM
