problem when cold start
#1
problem when cold start
Hi all
any ideas please!?
car has decided to not start well when cold.
starts fine time & time again once started an/or warm.
but when i go to work in the morning & its been sat over night, the starter kicks in all ok as usual, the engine goes to turn but the revs are very low & sometimes takes 2 or 3 turns for it to go.
tick over is fine once running, engine runs fine, no weird noises, coil packs are new, plugs are new a few months ago (will take out & clean though to be sure are ok) also had a temp sender unit last year.
only thing i have changed before the day this started is the 3 port solenoid set up for another.
checked the pipes, all seem ok, changed the 'diamond' part on the back of the 3 port bracket back to the one i had & thats not made any difference either.
could it still be any part of the 3 port solenoid system or has the starter decided to become lazy?
also got a walbro & thats all working fine for the fueling & the fuel filter was replaced with new last year
anyone ? thanks
any ideas please!?
car has decided to not start well when cold.
starts fine time & time again once started an/or warm.
but when i go to work in the morning & its been sat over night, the starter kicks in all ok as usual, the engine goes to turn but the revs are very low & sometimes takes 2 or 3 turns for it to go.
tick over is fine once running, engine runs fine, no weird noises, coil packs are new, plugs are new a few months ago (will take out & clean though to be sure are ok) also had a temp sender unit last year.
only thing i have changed before the day this started is the 3 port solenoid set up for another.
checked the pipes, all seem ok, changed the 'diamond' part on the back of the 3 port bracket back to the one i had & thats not made any difference either.
could it still be any part of the 3 port solenoid system or has the starter decided to become lazy?
also got a walbro & thats all working fine for the fueling & the fuel filter was replaced with new last year
anyone ? thanks
Last edited by timmyajmy93wrx; 29 July 2011 at 12:57 PM.
#6
had a new one last year mate, but i have found out from the ecu flashing it pointed ti the idle control solenoid thing code 24, cleaned it up asit wasnot veery free, so reset ecu an took for a drive an all seems ok, so will see what its like in the mornin!
Thread
Thread Starter
Forum
Replies
Last Post