wont start after rebuild
#1
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Jun 2010
Posts: 817
Likes: 0
Received 0 Likes
on
0 Posts
wont start after rebuild
just rebuilt a my97 uk2000, engine in and everything connected and i wont start sometimes backfires through inlet, ive got fuel and a good spark and ive just checked timing which is spot on even whipped cam covers off to make sure cams correct and all ok.
any help would be great.
any help would be great.
#4
switch plugs round mate you can only be wrong once as theres only 2 a side, i did that plug coilpacks in and it wouldnt start just backfired everynow and then switched plugs roung and fired up straight away
#7
Scooby Regular
iTrader: (13)
Join Date: Sep 2005
Location: Dublin, Eire
Posts: 2,785
Likes: 0
Received 0 Likes
on
0 Posts
Timing wrong mark on crank pulley.
Or fuel lines feed and return wrong way round.
Ecu not get cam or crank signal correctly.
Or fuel lines feed and return wrong way round.
Ecu not get cam or crank signal correctly.
Last edited by LegacySTi; 08 August 2011 at 06:56 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
toyney83
General Technical
10
02 October 2015 08:38 PM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM