Hi I have a 95 Sti and am doing a lot to her but need a bit of help if I am having a apexi pfc and a apexi avcr will I need to get a new map sensor like the MY 97 –00 map sensor higher pressure rating pleas help me thanks

 

IIRC you will need one.

Can't remember for sure though.

 

Can some one say 100 yes or no as will have to get one if I need it thanks

 

No later map sensors don't always work well with the basic Apexi ECU setup from experience. in any case you control the boost from the components of the AVCR package anyway. You should have the AVC-R boost pressure sensor and AVC-R boost pressure solenoid valve with your control unit and loom

 

I must be telling the truth too as I have a 99STi map sensor forsale converted for 95STi wiring and I haven't tried to sell it to you

 

Yes I have m8 so will I still need it if so what you looking for it m8

 

No you don't need it

 

Nice one mate thanks for that as it is just costing a **** load rite now but can't what to get he back on the road

 

You have a few options.

A boost controller - avcr is very good but any would work.
Get an apexi boost control kit which includes the apexi map sensor.
Get the apexi map sensor and loom separately.
Or fit the newer sensor as 53 has for sale however the boost reading will be wrong in the apexi. Iirc it will read 0.4bar lower than actual boost. So if you have a boost gauge to show you the boost level to stop confusion and whomever is mapping it is happy with you going that route it is the cheapest and retains a boost cut level which the boost controller alone wont.

Simon

 

Hi m8 have a apexi pfc and a apexi avcr full kit in box so will this be ok then and can I pm you my spec for a bit more help thanks

 

Sorted then, sorry missed that in your posts.

Of course

 

Thanks yhpm m8