Just fitted a Bolt In roll cage and have a problem :-(
11 July 2013 | 01:25 AM
#1
Just fitted a Bolt In roll cage and have a problem :-(
Hi Guys.
I've just fitted a OMP Bolt in roll cage and found a problem.
Front and middle legs are symmetrical to each other but rear backstays aren't. One side is 10mm lower/higher than the other. While installing this cage I've checked front and middle legs if they're symmetrical to each other but didn't do it with rear ones thinking that they will be OK.
Can I leave it like that or it has to be adjust it ?
Drivers side
Passenger side
Thank You
I've just fitted a OMP Bolt in roll cage and found a problem.
Front and middle legs are symmetrical to each other but rear backstays aren't. One side is 10mm lower/higher than the other. While installing this cage I've checked front and middle legs if they're symmetrical to each other but didn't do it with rear ones thinking that they will be OK.
Can I leave it like that or it has to be adjust it ?
Drivers side
Passenger side
Thank You
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 04:08 PM
JonMc
Subaru Parts
22
06 February 2016 10:50 PM
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 08:28 PM