As above really- my scooby is now a rally car, and the godspeed discs could do with replacing (after 5 years hard use), but their website seems not to work?

Im trying to avoid spending 600 odd on performance friction, as have a few other things to buy- OE discs wont do.

Cheers

Grant

 

I tried to get on too, no go! I wonder what's up.....

 

Been on to our webguys since last night to sort it out , they reckon it should be up and running within the hour.

 

Thanks Ian- I should have caught up when you were over in Jersey! Hope you enjoyed it- my first large event!

 

Did you get my message too Ian? It's about brembos from a 2010 car.

 

not sure what PFC discs you were after at 600+ ?? most of ther AP type fit rotors are well under this even at RRP

we carry a number of PFC options on the shelf (and AP, etc.) and can generally assist on pricing for competitors, etc.

 

Ian I messaged you through hear a little while ago, but no reply. Was about my brakes clunking, I can understand your very busy ect so no probs, but put the car in with the three arches now so they are going to have a look at the issue because I'm having a few other bits and bobs sorted as well.

 

At 110 or so for front grooved discs, I forgot what a bargain they were! You dont happen to sell 'knock back' or 'knock off' caliper springs for Brembo's too do you?

 

There is a way to fit them , but it means machining the calipers , and then you can only fit the WRX 290mm rear disc , if you want the 316mm STi rear discs get the earlier gold calipers , its a better , easier kit to fit

Could be a couple of things , best to ring and I can run through it

I can supply you springs , but generally find they are not needed , are you having pad knock off , if so are the wheel bearings ok

 

Spot on matey, thanks for the advice