TD05 Front Entry Conversion
20 January 2014, 12:21 PM
#1
Scooby Regular
Thread Starter
TD05 Front Entry Conversion
Hi All,
I've got hold of a TD05H with the upswept inlet. Looking to fit this to my 2003 WRX Wagon. Obviously I need to convert it to front entry.
Is it best to just swap the front housing over for a FE converted one (If so where do I get one)? Or convert the existing housing?
I'm going to remove the compressor housing either way as there is a slight bit of surface rust on the compressor wheel that I want to clean up before its fitted.
Cheers,
I've got hold of a TD05H with the upswept inlet. Looking to fit this to my 2003 WRX Wagon. Obviously I need to convert it to front entry.
Is it best to just swap the front housing over for a FE converted one (If so where do I get one)? Or convert the existing housing?
I'm going to remove the compressor housing either way as there is a slight bit of surface rust on the compressor wheel that I want to clean up before its fitted.
Cheers,
20 January 2014, 02:03 PM
#2
Scooby Regular
iTrader: (1)
Join Date: Sep 2007
Location: whittlesey ,
Posts: 878
Likes: 0
Received 0 Likes
on
0 Posts
most people convert the one they got by cutting it and welding so is straight ..thats what i did to mine anyway ,i took it to a welder about £25 and all done ,been ok
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM