me radio doesn't fit
14 March 2004 | 01:03 PM
#1
Thread Starter
Scooby Regular
Joined: Nov 2003
Posts: 471
Likes: 0
From: 323bhp.............. Scarborough
me radio doesn't fit
hi
just bought a version 6 type r limited and the hole for the radio isn't big enough?????? its about 5/10mm to narrow.
don't really want to start chopping up the center console, but is that the only way round it?
do they have slightly smaller radios in jap land??
cheers stevie boy
just bought a version 6 type r limited and the hole for the radio isn't big enough?????? its about 5/10mm to narrow.
don't really want to start chopping up the center console, but is that the only way round it?
do they have slightly smaller radios in jap land??
cheers stevie boy
14 March 2004 | 01:52 PM
#2
Scooby Regular
Joined: Jan 2002
Posts: 303
Likes: 0
It should fit,most radios have a clip on plastic surround that you have to take off then the plastic surround of the centre console will fit over it.You have to take the centre console surround off first to fit the radio.
Last edited by stevejohnson511; 14 March 2004 at 01:54 PM.
16 March 2004 | 03:20 PM
#3
Scooby Regular
Joined: May 2000
Posts: 925
Likes: 0
DIN sizes are the same everywhere.
You have to remove your dash surround first, you can't just slide the unit through the hole.
This is quite easy and once you have it off, it's just a matter of a few minutes to install the unit.
You have to remove your dash surround first, you can't just slide the unit through the hole.
This is quite easy and once you have it off, it's just a matter of a few minutes to install the unit.
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM