Does anybody know or has done an easy way to thread Speaker wire to the Front Door Speakers. I have had a look on a few occasions and gave up. But now it's starting to annoy me and it's the only part of my system on subaru cabling. So any advice would be gratefull thanks.

 

Hi, millersoviet.
its very straight forward remove door card remove step protector and footwell outer plastic moulding.
at this point remove foam from cavity to gain access to door wiring.
the hardest part with window up un-plug all wires in the door, CL,EW,Speakers, get a small mirror and look up to the wiring point as it leaves the door you will see a plastic clip you will have to cut this as there is no easy way to unclip it.
remove the wiring from the door and then thread this through to the interior of the car. you willsee a large amount of tape that extend the door cavity grommet carefully cut this back but dont cut the gromet.
try and straighten the gromet as much as possible,
get a can of WD40 or simmilar spray into the gromet,
Now with your new speaker wire tape up 20" of wire adn squeeze it through this takes some time then replace all in reverse order,

 

Cool, will attempt tomorrow and let know how I went on.

 

Worked A Treat Thanks.