any one have wiring diagrams for MY98
#1
Scooby Regular
Thread Starter
Join Date: Mar 2003
Location: Edinburgh
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
i have fitted a turbo timer but want to be able to alarm the car when its running i am following some instructions off the web and it says at the end
33. Last but not least, we need to be able to arm the car while the turbo timer counting down.
34. Look up under the dash on the driver's side and locate the keyless entry/alarm module, it's pretty far under there behind the fuse block. There is a wiring pin-out sticker on it, look for pin 6, it should say ignition. That's what we are looking for.
35. Peel back some tape and cut the ignition wire about three inches from the harness. The wire is green with a black stripe, I THINK. Tape up both ends.
i can find a black box above the fuse panel that says door lock timer on it and has a green/black wire going to it but i want to make shure it is the correct one because its above the fuse box and not behind it. i have had a good look up under there and cant see any other module not with a green/ black wire anyway.
can anyone help with this. or is there any wiring diagrams out there i can look at
[Edited by scoobyguy22 - 1/16/2004 3:39:50 PM]
33. Last but not least, we need to be able to arm the car while the turbo timer counting down.
34. Look up under the dash on the driver's side and locate the keyless entry/alarm module, it's pretty far under there behind the fuse block. There is a wiring pin-out sticker on it, look for pin 6, it should say ignition. That's what we are looking for.
35. Peel back some tape and cut the ignition wire about three inches from the harness. The wire is green with a black stripe, I THINK. Tape up both ends.
i can find a black box above the fuse panel that says door lock timer on it and has a green/black wire going to it but i want to make shure it is the correct one because its above the fuse box and not behind it. i have had a good look up under there and cant see any other module not with a green/ black wire anyway.
can anyone help with this. or is there any wiring diagrams out there i can look at
[Edited by scoobyguy22 - 1/16/2004 3:39:50 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM