SWITCH BULBS
#1
SWITCH BULBS
IAM LOOKING FOR THE SMALL BULBS FOR THE HAZARD LIGHT SWITCH AND THE REAR DEMIST SWITCH.MY LOCAL DEALER CAN'T GET THEM THEY SAY.THEY ARE FOR A 1995 JAP IMPORT
#3
the bulbs iam on about does not have wire ends on them.they are very small bulbs with a coloured cover on them.they also have a square connector block on the back of them
#4
Scooby Regular
iTrader: (2)
I THINK, IIRC, that the square connector has the wire ended bulb in it. Mine did, for my HRW switch. If you look closely, you can see that the wires from the bulb thread through the square connector, and then back through, and make contact with pins inside the switch when the connector is pressed into place. the old bulb has to have it's wires threaded out, and the new ones threaded in. Take care to note exactly HOW the wires are threaded into the connector. Tweezers, and sidecutters, (or sharp scissors), are useful, as is a lot of patience and bloody good eyesight!
Alcazar
Alcazar
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
jonnyboy82
Lighting and Other Electrical
0
29 September 2015 01:59 PM