HKS EVC 4 Wiring
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2007
Location: Worthing
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
HKS EVC 4 Wiring
Does anyone have the above mentioned boost controllers wiring diagram and fitting instrucitons. I dont have the power loom so am looking to splice it in somewhere, but i dont know what the wires are!!!
Thanks Mike
Thanks Mike
#2
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2007
Location: Worthing
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
ok i found the needed bits, but now i have it in place its over boosting like mad, i have re set the unit so it can find out the stock pressure, and i have checked all the pipes and its still doing it. I have removed the pipe with the restrictor in it, does this still need to be in, would that not make the boost spike even more?
I havent been brave enough to see how far the boost spikes, but it went over 1.5bar, which was high enough for me! unless the unit is not working right, then i cant see why it would over boost!
Any ideas and help would be mucho appreciated!
Thanks MIke
I havent been brave enough to see how far the boost spikes, but it went over 1.5bar, which was high enough for me! unless the unit is not working right, then i cant see why it would over boost!
Any ideas and help would be mucho appreciated!
Thanks MIke
#3
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2007
Location: Worthing
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
ok i have tried what i can, it still over boosts, but settles to 1.1 ish, but if i push it too much it hits fuel cut, so either the unit is buggered or i am doing something very wrong!! but i have followed the instructions to the letter!!
getting a bit frustrated now!
getting a bit frustrated now!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM