Wiring loom mods advice, Newage WRX to Sti Engine Swap.
11 July 2010, 09:39 AM
#1
Scooby Regular
Thread Starter
iTrader: (21)
Join Date: Jul 2005
Location: North West
Posts: 1,236
Likes: 0
Received 0 Likes
on
0 Posts
Wiring loom mods advice, Newage WRX to Sti Engine Swap.
Anyone have any advice on doing a WRX wiring loom conversion for a newage STi EJ20 engine swap. Ive researched that a few extra wires are needed for the AVCS sensors which I can utilise from a Sti loom that I have salvaged along with an ECU which will be replaced. Im also looking at replacing the JDM indicator stalk set up from right to left and would be interested in any information on this.
Thanks
Thanks
16 July 2010, 01:58 PM
#2
Scooby Regular
Anyone have any advice on doing a WRX wiring loom conversion for a newage STi EJ20 engine swap. Ive researched that a few extra wires are needed for the AVCS sensors which I can utilise from a Sti loom that I have salvaged along with an ECU which will be replaced. Im also looking at replacing the JDM indicator stalk set up from right to left and would be interested in any information on this.
Thanks
Thanks
04 September 2010, 03:22 PM
#3
Scooby Regular
Putting this here because the title is more direct for anyone else looking to convert over!
http://www.ds1motorsports.com/assets...l_document.pdf
http://www.ds1motorsports.com/assets...l_document.pdf
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
