LewisL

iTrader: (3)

Just wired I a LED shift light on pin 1 & 6 of conector 2 but its on permantley do I nee to fit a resistor or something inline?

Thanks

JDM_Stig

iTrader: (3)

http://forums.nasioc.com/forums/showthread.php?t=814471

are you sure it`s not one of your other alarms that's causing it, you wouldn't have known until now as nothing was connected to the output.

LewisL

iTrader: (3)

Soon as ignition is on the light is on

LewisL

iTrader: (3)

After reaing that the oil pressure might need changing as I am not running sensor yet

LewisL

iTrader: (3)

Nope all the alarms are seet correcty and its still just on all the time???

LewisL

iTrader: (3)

Also the light stays on with ignition off inly time it goes out Ia if yoi pull. The plug from the odb port

JDM_Stig

iTrader: (3)

do you have the right instructions for your PSI3, Im wondering if you have the wrong connections, or your psi is on the blink.

LewisL

iTrader: (3)

Its fresh. Back from simon being upgraded and he put a copy othe instructions in with it

JDM_Stig

iTrader: (3)

might be worth asking him then tbh if you contact details

LewisL

iTrader: (3)

I have but he isn't in the opffice til tuesday so wondered if anybody. Here had any ideas

I just tried running a 1k resistor across. Pins 1 and 2 of connector 2 as simon mentioned that but made no differernce

I'm not runni g oil temp and press sensors yet but they defult at 1degree and 98 psi and I have the alaarmsset at 0 for both so that shouldn't cause an alarm battery is fine as is coolant as is boost

LewisL

iTrader: (3)

All sorted now simon gave me a different pin combo to try today and it worked

JDM_Stig

iTrader: (3)

ahh so the instructions arent right you have ?

LewisL

iTrader: (3)

No I had it all upgraded but obviously the pin setup must of stayed Ag the old configuration