FS: Inlet manifold spacers..

Thread Tools

Search this Thread

10 September 2003, 02:23 PM

cswminty

Scooby Regular

Thread Starter

Join Date: Dec 2002

Posts: 329

Likes: 0

Received 0 Likes on 0 Posts

YHM

10 September 2003, 06:41 PM

colin c

Scooby Regular

Join Date: Jan 2001

Location: Southampton, 12.7 1/4 mile purple Scooby

Posts: 839

Likes: 0

Received 0 Likes on 0 Posts

Hi David,

Will 8mm be enough to allow a TD05 front entry mod on a 94WRX. If so I will have a set and possibly a 2nd set for a mate who is planning the same mod. Phase 1 obviously required.

Cheers Colin.

09 October 2003, 01:48 PM

David_Wallis

Scooby Regular

Join Date: Nov 2001

Location: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?

Posts: 15,239

Likes: 0

Received 1 Like on 1 Post

I made some inlet manifold spacers for my car and accidently made some spare so I have some sets for sale..

For some reason I made phase 1 and Phase 2..

made from 8mm Nylon 66.. properties are as follows...

Specific gravity 1·14 - 1·15
Water absorption 8·5% max. saturation
Tensile strength 70/90MPa
Flexural strength 2830MPa
Shear strength 66N/mm2
Hardness (shore D) 80-85
Melt point 255°C
Min. temp. -30°C
Thermal conductivity 0·23W/k.m
Flammability UL94V-2
Volume resistivity 1012-1015 Ohm. cm.
Dielectric strength 28-30kV/mm
Comparative tracking index 600V kA 3c

Price is £45 per pair.

I could arrange to find some thicker ones..

David

[Edited by David_Wallis - 9/10/2003 2:34:59 PM]