Possible sale of high spec WRX bottom end
#1
Scooby Regular
Thread Starter
Join Date: Jan 2001
Location: Down South to Ooop North to Back Down South again!!
Posts: 6,633
Likes: 0
Received 0 Likes
on
0 Posts
Possible sale of high spec WRX bottom end
Just wanted to gauge how much i'd get for this?:
Firstly the block on the no.1 cylinder side has been scored so that the 0.5mm oversized piston would no longer fit). One of the pistons is damaged & a valve has been bent.
The remaining parts listed below are fine & have only done approx 11k:
3 x forged cosworth pistons ( +1 damaged) 0.5mm oversized
4 x steel rods
long stroke (2.2 stroker kit)
balanced crank
The whole bottom end would be sold as a whole unit. Would be a good starting point to a very powerful engine. All that would be needed is a new bottom end bored to fit the pistons, 1 new piston, rings & a valve.
Offers
Firstly the block on the no.1 cylinder side has been scored so that the 0.5mm oversized piston would no longer fit). One of the pistons is damaged & a valve has been bent.
The remaining parts listed below are fine & have only done approx 11k:
3 x forged cosworth pistons ( +1 damaged) 0.5mm oversized
4 x steel rods
long stroke (2.2 stroker kit)
balanced crank
The whole bottom end would be sold as a whole unit. Would be a good starting point to a very powerful engine. All that would be needed is a new bottom end bored to fit the pistons, 1 new piston, rings & a valve.
Offers
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
BHPvstorque
Subaru Parts
1
14 September 2015 08:31 PM