Afterburner Vortex Angled Exit
04 July 2005, 07:34 PM
#1
Afterburner Vortex Angled Exit
I have an Afterburner Vortex Angled Exit for sale,
Originally it was fitted to my old bugeye but has now been converted to fit a Classic Turbo.
When I had it converted I had a slight kink put in the pipe to give extra clearance around the drive shaft
On the car
I also had a home designed bung made for it, but I as yet have not drilled the pipe to fix it in, it's the one on the left inspired by the one on the right.
This is just sitting in the end of the pipe but I had planned on sitting it in further
I'm looking for £170
Postage will be extra but I would prefer not to post it if at all possible.
I am going to Rally Day at Castle Coombe if that helps.
Regards
Simon
Originally it was fitted to my old bugeye but has now been converted to fit a Classic Turbo.
When I had it converted I had a slight kink put in the pipe to give extra clearance around the drive shaft
On the car
I also had a home designed bung made for it, but I as yet have not drilled the pipe to fix it in, it's the one on the left inspired by the one on the right.
This is just sitting in the end of the pipe but I had planned on sitting it in further
I'm looking for £170
Postage will be extra but I would prefer not to post it if at all possible.
I am going to Rally Day at Castle Coombe if that helps.
Regards
Simon
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM