APS S/R30 turbo
#4
Scooby Regular
Join Date: Jul 2003
Location: Behind the wheel of a Time Attack R33 GTR
Posts: 5,734
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
interesting to see your getting rid....seemed like a well set up car with it ![Smile](https://www.scoobynet.com/images/smilies/smile.gif)
bttt for a good turbo![Smile](https://www.scoobynet.com/images/smilies/smile.gif)
scoobboy, this turbo wont make anywhere near 400, it maxes at 350~
![Smile](https://www.scoobynet.com/images/smilies/smile.gif)
bttt for a good turbo
![Smile](https://www.scoobynet.com/images/smilies/smile.gif)
scoobboy, this turbo wont make anywhere near 400, it maxes at 350~
#5
Scooby Regular
Thread Starter
Join Date: Nov 2003
Location: MY02 WRX w/ Ver8 STi engine & 6MT
Posts: 617
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Correct Neilo its rated by APS to 340hp but there are guys on NASIOC running this turbo + alcy injection pushing 300 WHEEL HP. For 400+ you'd be better off with an APS SR40 or SR55 but thats getting big.. the key to this turbo is 340+ HP rating but with stock spool characteristics! Gotta love that Garrett GT dual ball bearing center section! Thats why these APS turbos cost so damn much.
I spoke with ATF Power and I am going to run the turbo over there tomorrow and get Gareth to give it a look over and see about the actuator. Just the kinda guy I am, NO JUNK HERE!
I spoke with ATF Power and I am going to run the turbo over there tomorrow and get Gareth to give it a look over and see about the actuator. Just the kinda guy I am, NO JUNK HERE!
#7
Scooby Regular
Thread Starter
Join Date: Nov 2003
Location: MY02 WRX w/ Ver8 STi engine & 6MT
Posts: 617
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Well the turbo has been looked over by ATF Power. No problems or damage has been noted. Gareth said its in very good condition with very little wear. He cleaned the flapper valve and wastegate and it seals properly.
Last edited by BVM; 08 May 2006 at 10:36 AM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post