GT30 Hybrid Turbo!
#1
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: Behind the wheel of a Time Attack R33 GTR
Posts: 5,734
Likes: 0
Received 0 Likes
on
0 Posts
GT30 Hybrid Turbo!
Im selling this turbo as i need something with a larger inlet. This is a large standard position GT30 based turbo, not for the faint hearted. This is ideally suited to 2.5 or 2.33 builds or high revving 2.0 builds. This will give you an almighty shove when you hit 4000 rpm and will continue to impale you to the seat until the redline.
With the correct supporting mods this is a 450bhp turbo @ ~1.8bar, My car is running at approx ~400 at 1.55bar and over 400lbft from 4200rpm. My car achieves 1 bar at 3000 rpm on UK heads, with a better setup it may even spool sooner than that too. It has a polished compressor cover and a ported inlet.
I has an uprated 1.25bar actuator. This is a 55lb/min turbo so can flow plenty of air if you give it the chance.
£750 o.n.o complete with braided oil line and water lines.
Pictures will be posted a little later
With the correct supporting mods this is a 450bhp turbo @ ~1.8bar, My car is running at approx ~400 at 1.55bar and over 400lbft from 4200rpm. My car achieves 1 bar at 3000 rpm on UK heads, with a better setup it may even spool sooner than that too. It has a polished compressor cover and a ported inlet.
I has an uprated 1.25bar actuator. This is a 55lb/min turbo so can flow plenty of air if you give it the chance.
£750 o.n.o complete with braided oil line and water lines.
Pictures will be posted a little later
#3
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: Behind the wheel of a Time Attack R33 GTR
Posts: 5,734
Likes: 0
Received 0 Likes
on
0 Posts
good point, should have mentionned that, this is "internally" gated. No external required, this is a straight bolt on turbo.
Also to add this had had around 2500 miles use and there is no play in the shaft.
Also to add this had had around 2500 miles use and there is no play in the shaft.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM