Classic Prodrive backbox swap?
30 August 2007, 03:02 PM
#1
Scooby Newbie
Thread Starter
Join Date: Jul 2007
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Classic Prodrive backbox swap?
Hi all,
Does anybody fancy swapping their backbox for my stainless Prodrive backbox? For a classic saloon. It's 3.5 inch diameter and exits straight, not angled. In good condition, only a few small scrapes on the bottom which can't be seen when mounted. I'm after a backbox that's a bit louder than the Prodrive - it sounds great but is a bit too quiet for what I'm after.
PM me if interested. Ideally I don't want one too big or one that exits at much of an angle.
JD
Does anybody fancy swapping their backbox for my stainless Prodrive backbox? For a classic saloon. It's 3.5 inch diameter and exits straight, not angled. In good condition, only a few small scrapes on the bottom which can't be seen when mounted. I'm after a backbox that's a bit louder than the Prodrive - it sounds great but is a bit too quiet for what I'm after.
PM me if interested. Ideally I don't want one too big or one that exits at much of an angle.
JD
![[Davey]'s Avatar](data:image/svg+xml;utf8,<svg xmlns='http://www.w3.org/2000/svg' viewBox='0 0 50 50'><circle class='avatar-circle-default' fill='%23806b84' cx='25px' cy='25px' r='20px'></circle><text class='avatar-text-default' x='49%' y='53%' fill='white' text-anchor='middle' alignment-baseline='middle'>[</text></svg>)
Thread
Thread Starter
Forum
Replies
Last Post