polo g40 engine!!
02 February 2002, 06:24 PM
#1
Scooby Regular
Thread Starter
Join Date: Jul 2001
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
i have a polo g40 engine, never been in a car, painted it red before i found out that i had to get a hydraulic head so it wont fit on a mk1 polo, but anything over a g reg(i am told) it will fit.
consists of just the engine block (not head) a little rusty on the side but just needs a rub down, was £350 from germany, also bought the cam belt, water pump, water pipe was £100 on its own.
total cost me more that £500.
give us £100 and you can take the lot.
i have put a normal head on the engine just to protect it but can remove to show it has never been used.
cheerz,
phil.
consists of just the engine block (not head) a little rusty on the side but just needs a rub down, was £350 from germany, also bought the cam belt, water pump, water pipe was £100 on its own.
total cost me more that £500.
give us £100 and you can take the lot.
i have put a normal head on the engine just to protect it but can remove to show it has never been used.
cheerz,
phil.
02 February 2002, 07:15 PM
#4
Scooby Regular
Join Date: May 2001
Location: Scotland
Posts: 4,580
Likes: 0
Received 0 Likes
on
0 Posts
I assume you've tried VW forums...
www.performancevw.com
www.awesomegti.com
www.germancarcompany.com
To name but a few
I reckon you'll have no probs selling that m8
Good luck
John
www.performancevw.com
www.awesomegti.com
www.germancarcompany.com
To name but a few
I reckon you'll have no probs selling that m8
Good luck
John
02 February 2002, 10:47 PM
#7
Scooby Regular
Join Date: May 2001
Location: Scotland
Posts: 4,580
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM
