Kenwood amp & Directed subs x 2
#1
Scooby Regular
Thread Starter
Join Date: Jun 2008
Location: Berkshire
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Kenwood amp & Directed subs x 2
KAC-9152D MAIN FETCHERS:
1,800 Watts max power
500 Watts x 1 max (4 ohms) RMS
900 Watts x 1 (2 ohms) RMS
900 Watts x 1 (1 ohms) RMS
Wired remote control to adjust boost level and frequency included
'Dual mono drive' configuration option (requires two KAC-9152D amplifiers & specialist knowledge!).
Aluminium die-cast heat sink.
Detachable aluminium top cover.
All connections on one side for easy multi-amplifier installations.
Built-in Variable Low-pass Filter 50-200Hz (24dB/oct).
Built-in Infrasonic Filter 15Hz/25Hz (18dB/oct) to cut unwanted ultra-low frequencies.
'Kenwood logo triangle' design power indicator LED.
1 ohm stable.
Gold plated RCA line input & line output terminals.
Speaker level input option. RCA line outputs.
Power MOSFET switching power supply.
'D' class amplification circuits throughout, using switching techniques instead of the linear methods used in Class 'A' or 'B' type amplifiers. Class 'D' is a significantly more efficient than Class 'A' or 'B', resulting in greater power. with less heat generation, higher stability and improved reliability.
2 x 30 amp power supply fuses .
Dimensions (WxHxD) : 380 x 61 x 286 mm.
Complete with full fitting and operating guide.
DIRECTED 3128 STUDIO SUBWOOFER X 2 MAIN FETCHERS:
Directed: 12'' Subwoofer - Studio 3128 Product Features 14mm Xmax (one-way linear excursion) Optimized for small sealed or vented enclosures Proprietary die-cast aluminum baskets for rock solid assembly Wide nitrile butyl rubber surrounds allow more excursion at low frequency Mineral-filled low resonance 1mm thick polypropylene cones Four layer, 2.5" diameter voice coils on black anodized aluminum formers Long throw motor assembly with bumped back plate and vented pole piece 100 oz. magnet stack with 150mm front plates Custom rubber magnet cover protects motor assembly 5-way gold binding posts accept heavy gauge cabling 500w RMS. Normally ?149.00
When i brought this lot it cost me over £500 and was only used for around 8 months and its all in exellent condition and all wired up ready to go and is a bargain at £150 so if you are intrested then let me know as its been sitting in my store cupboard so its going to waste.
This system is really loud and sounds amazing!!!!!
P.S the amp also comes with the remote controll to controll the base but forgot to include in the pic.
A BARGAIN AT £150!!!!
Thanks
Adam
1,800 Watts max power
500 Watts x 1 max (4 ohms) RMS
900 Watts x 1 (2 ohms) RMS
900 Watts x 1 (1 ohms) RMS
Wired remote control to adjust boost level and frequency included
'Dual mono drive' configuration option (requires two KAC-9152D amplifiers & specialist knowledge!).
Aluminium die-cast heat sink.
Detachable aluminium top cover.
All connections on one side for easy multi-amplifier installations.
Built-in Variable Low-pass Filter 50-200Hz (24dB/oct).
Built-in Infrasonic Filter 15Hz/25Hz (18dB/oct) to cut unwanted ultra-low frequencies.
'Kenwood logo triangle' design power indicator LED.
1 ohm stable.
Gold plated RCA line input & line output terminals.
Speaker level input option. RCA line outputs.
Power MOSFET switching power supply.
'D' class amplification circuits throughout, using switching techniques instead of the linear methods used in Class 'A' or 'B' type amplifiers. Class 'D' is a significantly more efficient than Class 'A' or 'B', resulting in greater power. with less heat generation, higher stability and improved reliability.
2 x 30 amp power supply fuses .
Dimensions (WxHxD) : 380 x 61 x 286 mm.
Complete with full fitting and operating guide.
DIRECTED 3128 STUDIO SUBWOOFER X 2 MAIN FETCHERS:
Directed: 12'' Subwoofer - Studio 3128 Product Features 14mm Xmax (one-way linear excursion) Optimized for small sealed or vented enclosures Proprietary die-cast aluminum baskets for rock solid assembly Wide nitrile butyl rubber surrounds allow more excursion at low frequency Mineral-filled low resonance 1mm thick polypropylene cones Four layer, 2.5" diameter voice coils on black anodized aluminum formers Long throw motor assembly with bumped back plate and vented pole piece 100 oz. magnet stack with 150mm front plates Custom rubber magnet cover protects motor assembly 5-way gold binding posts accept heavy gauge cabling 500w RMS. Normally ?149.00
When i brought this lot it cost me over £500 and was only used for around 8 months and its all in exellent condition and all wired up ready to go and is a bargain at £150 so if you are intrested then let me know as its been sitting in my store cupboard so its going to waste.
This system is really loud and sounds amazing!!!!!
P.S the amp also comes with the remote controll to controll the base but forgot to include in the pic.
A BARGAIN AT £150!!!!
Thanks
Adam
Last edited by Northy 7; 11 February 2009 at 06:37 PM.
#3
Scooby Regular
Thread Starter
Join Date: Jun 2008
Location: Berkshire
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
gazzawrx
Non Car Related Items For sale
13
17 October 2015 06:51 PM