Classic parts
10 March 2009, 10:20 PM
#1
Scooby Regular
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Posts: 887
Likes: 0
Received 0 Likes
on
0 Posts
Classic parts
Its time to clear some space from my garage and shed, so these parts have to go.
Everything is fine or I wouldn't sell it. PM for further info on any of the following, or for delivery costs.
I am located in Aberdeenshire Scotland. Delivery is available at cost but please allow a few days for this as I dont always get time to post items right away.
Engine:-
UK turbo block - all present and correct, no noise or issues. Was used in my car for 70k miles, removed to fit an STI engine.
UK turbo heads - to go with the block above. Again all present and correct, no issues. No cam pulleys though.
It was run at standard boost with no more than a back box fitted for most of its life then a full de-cat for the last 6k!!
The block was changed followed by the heads 6 months later thats why the heads are off the block. Any inspection welcome.
I can also supply new head gaskets at extra cost.
Block = £250
Heads = £100
Both = £330
TD04 Turbo. 70k miles, standard boost, I removed it to fit a VF35
£40
Rear diff for UK Turbo - R160 from a MY97 UK turbo, perfect condition
£80
Clutch from UK turbo - Used but lots of life left. Done about 25k miles Was in my car but I needed to go for an uprated item when I changed the turbo and engine.
SOLD
Phase 1.5 fuel rails - Ideal if you want to send these away and have them converted to -6 fittings for parallel fuel rails.
£15
MAF sensor - from MY97 UK turbo, purple label I believe.
SOLD
Set of OE headers, All heat shields removed and lugs etc cut and grinded down ready for porting and wrapping. Were removed from my own car.
SOLD
K&N induction cone - Again from MY97 UK Turbo Comes with the wee hose to go from MAF to Cone. I'll get the part No later.
£30
Baileys dump valve for early classics (pre 98), not bolted to the Inter Cooler.
£50 RESERVED
Front fogs for a pre facelife bumper - perfect condition, no rust or cracks, removed from my car in favour of covers
SOLD
Front bumper for classic STI, pre facelift (3-slat), has been cut to fit front mount inter cooler or mesh. Will need paint to make it right.
£30
Full A/C kit - or if you only need part of it let me know.
£20
Everything is fine or I wouldn't sell it. PM for further info on any of the following, or for delivery costs.
I am located in Aberdeenshire Scotland. Delivery is available at cost but please allow a few days for this as I dont always get time to post items right away.
Engine:-
UK turbo block - all present and correct, no noise or issues. Was used in my car for 70k miles, removed to fit an STI engine.
UK turbo heads - to go with the block above. Again all present and correct, no issues. No cam pulleys though.
It was run at standard boost with no more than a back box fitted for most of its life then a full de-cat for the last 6k!!
The block was changed followed by the heads 6 months later thats why the heads are off the block. Any inspection welcome.
I can also supply new head gaskets at extra cost.
Block = £250
Heads = £100
Both = £330
TD04 Turbo. 70k miles, standard boost, I removed it to fit a VF35
£40
Rear diff for UK Turbo - R160 from a MY97 UK turbo, perfect condition
£80
Clutch from UK turbo - Used but lots of life left. Done about 25k miles Was in my car but I needed to go for an uprated item when I changed the turbo and engine.
SOLD
Phase 1.5 fuel rails - Ideal if you want to send these away and have them converted to -6 fittings for parallel fuel rails.
£15
MAF sensor - from MY97 UK turbo, purple label I believe.
SOLD
Set of OE headers, All heat shields removed and lugs etc cut and grinded down ready for porting and wrapping. Were removed from my own car.
SOLD
K&N induction cone - Again from MY97 UK Turbo Comes with the wee hose to go from MAF to Cone. I'll get the part No later.
£30
Baileys dump valve for early classics (pre 98), not bolted to the Inter Cooler.
£50 RESERVED
Front fogs for a pre facelife bumper - perfect condition, no rust or cracks, removed from my car in favour of covers
SOLD
Front bumper for classic STI, pre facelift (3-slat), has been cut to fit front mount inter cooler or mesh. Will need paint to make it right.
£30
Full A/C kit - or if you only need part of it let me know.
£20
Last edited by duncatr; 02 April 2009 at 01:02 PM.
Could i please have the Maf sensor,if is in good working order
11 March 2009, 12:26 PM
#3
Scooby Regular
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Posts: 887
Likes: 0
Received 0 Likes
on
0 Posts
No probs.
It is in perfect working order.
It was only removed to fit an STI orange label item as I was going for more power and this one would have been on the limit for monitoring the amount of air flow I wanted.
PM on its way.
It is in perfect working order.
It was only removed to fit an STI orange label item as I was going for more power and this one would have been on the limit for monitoring the amount of air flow I wanted.
PM on its way.
Trending Topics
13 March 2009, 12:35 PM
#9
Scooby Regular
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Posts: 887
Likes: 0
Received 0 Likes
on
0 Posts
I'll go through it all at the weekend, list everything and check its all there and in good condition.
It was working fine when it was removed from my car.
Will need re-gassed but other than that its fine.
17 March 2009, 06:49 PM
#11
Scooby Regular
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Posts: 887
Likes: 0
Received 0 Likes
on
0 Posts
My apologies folks.
I have been ill for a few days and not managed to look at anything or post anything. I'm only just starting to recover today but still far from 100%.
I'll try and get back onto this ASAP. Although it might not be till Thursday.
Sorry for any inconvenience.
Duncan
I have been ill for a few days and not managed to look at anything or post anything. I'm only just starting to recover today but still far from 100%.
I'll try and get back onto this ASAP. Although it might not be till Thursday.
Sorry for any inconvenience.
Duncan
01 April 2009, 02:54 PM
#19
Scooby Regular
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Posts: 887
Likes: 0
Received 0 Likes
on
0 Posts
Hi sorry for the delay.
I have everything here.
Pump (including bracket), condensor, radiator and all pipes.
It all seems to be in good contition, it has been sitting in my shed for about 6 months doing nothing.
Let me know if your still interested mate.
I have everything here.
Pump (including bracket), condensor, radiator and all pipes.
It all seems to be in good contition, it has been sitting in my shed for about 6 months doing nothing.
Let me know if your still interested mate.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM