STI V7 short motor - forged pistons - very good condition - removed due to upgrade
01 November 2009, 07:10 PM
#1
STI V7 short motor - forged pistons - very good condition - removed due to upgrade
Well my short motor is stripped and for sale.
2002 Sti V7 motor, assembled block with crank, rods, bearings, pistons etc.
No heads or oil pan included
These motors came with sti forged pistons as standard. Pistons/bores in very nice condition with no marks on any cylinders. No debris of any kind was found in the oil pickup or AVCS filters.
Engine removed due to 2.5 upgrade and was running beautifully when removed.
Car covered 35k miles, always warmed up, cooled down with regular oil changes using Motul competition oil.
This motor will make a perfect upgrade for someone whos engine has failed or looking to run 400bhp+
Please also bear in mind it has been stripped by a professional engine builder and cleanliness has been of upmost importance.
Looking for £500
2002 Sti V7 motor, assembled block with crank, rods, bearings, pistons etc.
No heads or oil pan included
These motors came with sti forged pistons as standard. Pistons/bores in very nice condition with no marks on any cylinders. No debris of any kind was found in the oil pickup or AVCS filters.
Engine removed due to 2.5 upgrade and was running beautifully when removed.
Car covered 35k miles, always warmed up, cooled down with regular oil changes using Motul competition oil.
This motor will make a perfect upgrade for someone whos engine has failed or looking to run 400bhp+
Please also bear in mind it has been stripped by a professional engine builder and cleanliness has been of upmost importance.
Looking for £500
Last edited by frayz; 01 November 2009 at 07:15 PM.
02 November 2009, 01:45 AM
#7
Scooby Regular
iTrader: (5)
Join Date: Nov 2007
Location: Kenya
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
if i want to put this in a classic STI v3, will i need a version 7 wiring loom as well?? Also will the version 3 inlet manifold and oil pan fit on this block?
Cheers,
Imran
if i want to put this in a classic STI v3, will i need a version 7 wiring loom as well?? Also will the version 3 inlet manifold and oil pan fit on this block?
Cheers,
Imran
Trending Topics
02 November 2009, 10:26 AM
#11
I have lots of guys PM'ing and emailing about this guys. If im honest id rather not ship it abroard.
I already have a small que forming. I will thank you all for your interest and keep you all posted.
kindest regards
Frayz
I already have a small que forming. I will thank you all for your interest and keep you all posted.
kindest regards
Frayz
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
Scooby-Doo 2
Subaru Parts
8
26 September 2015 02:09 PM
