Do I need a re-map?
#1
Scooby Regular
Thread Starter
Do I need a re-map?
What with all this pollution and smog?
I'm sure I could do with a re-map .... anyone know a man with det-cans?
.
.
.
.
.
.
.
.
I'm sure I could do with a re-map .... anyone know a man with det-cans?
.
.
.
.
.
.
.
.
#3
Scooby Regular
The *legend* that is pslewis..
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
(t)rolling our the same pish on Scoobynet for the past 13 years
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
(t)rolling our the same pish on Scoobynet for the past 13 years
#4
Scooby Regular
iTrader: (5)
OMG................Where did you spring from?
Yes, of course you need a re-map - and another one once the pollution has cleared!
You also need to do an oil/filter change using Tesco value range oil, not forgetting to disconnect the crank sensor and flatten the battery on the starter otherwise the bearings will run after less than 50 miles.
Welcome back
JohnD
Yes, of course you need a re-map - and another one once the pollution has cleared!
You also need to do an oil/filter change using Tesco value range oil, not forgetting to disconnect the crank sensor and flatten the battery on the starter otherwise the bearings will run after less than 50 miles.
Welcome back
JohnD
#6
Scooby Regular
Thread Starter
I wouldn't have worried about it normally, it was my CockLink flashing red LED's at me that got me thinking.
I may change the Oil after the re-map ... just to make sure, and disconnect the camshaft sensor in case it accidentally starts and melts the seats.
JohnD - I've been around on NSR ... I only come in here when I want Technical advice.
I may change the Oil after the re-map ... just to make sure, and disconnect the camshaft sensor in case it accidentally starts and melts the seats.
JohnD - I've been around on NSR ... I only come in here when I want Technical advice.
Thread
Thread Starter
Forum
Replies
Last Post
DannyBoyTurbo
General Technical
2
23 December 2002 05:44 PM