Classic type r advice
#1
Classic type r advice
Hi I've looked at a classic type r that has not been used allot since 2008 if I am to buy it what would you recommend doing to it asap eg belts ,service wise? It's done about 70000 miles
#7
define alot, what history has it got since 08? My old car was rarley used but still have service as per book and 6 month oil changes
worst case, tyres, all fluids, cambelts, full check over for any perished hoses in the engine bay etc etc and its a risk.
worst case, tyres, all fluids, cambelts, full check over for any perished hoses in the engine bay etc etc and its a risk.
Trending Topics
#8
Type r
Hi it's done 10k since 2008 buy a guy in his 70's now! He bought it as an investment but has no room now for it! If I was to take it straight to zen for belts, fluids and a full once over do you think it's worth the risk for 5k
#11
Should I snap it up then? It needs service and belts, 4 Tyres, and bonnet wings and side skirts need spraying as they've been sprayed badly then it will be mint! So I think it will be 7k when finished
#12
need to check out the arches and then you wont know how goo it runs till you can get it checked out, i bought mine for 6 and the engien let go after 4k miles, done alot more milage (104k) than that, but similar age cars of course
#13
Snap!
I'm in Rugby too, and own a type R. Where abouts in Rugby are you?
Garage wise i'd recommend TDRacing in Warwick mate, if you say Paul sent you Mark will look after you ;-)
http://tdracing.co.uk/
Also got RCM up the road in Hinckley if you have deep pockets
Paul
I'm in Rugby too, and own a type R. Where abouts in Rugby are you?
Garage wise i'd recommend TDRacing in Warwick mate, if you say Paul sent you Mark will look after you ;-)
http://tdracing.co.uk/
Also got RCM up the road in Hinckley if you have deep pockets
Paul
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 04:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 09:16 AM
hedgecutter
General Technical
3
25 September 2015 03:35 PM