forehead

Does anyone know any web sites that show how to fit one of the these

Johnny50

What MY you got ?

Tis a simple job...10 mins max.

Even i managed it on mine once !

forehead

MY01

MickeyWRX

ring forge mate and they will tell you - they helped me and is fairly simple!

forehead

I would but I bought it in the Forum and not from them - so I thought that would be taking the p*ss a bit

CHRIS_D

ive just put one on my MY99 so i would assume its the same fitment to yours.

If you want i will e-mail pics and knock out a quick set of instructions, unfortunately im not 'geeky' enough to be able to construct my own website yet

drop me an e-mail if you want

chris

MarksWRX

Couldn't be simpler m8.
Disconnect the small (10mm ish) vacuum hose from the top of your original. Disconnect the large (25mm ish) recirc hose from the bottom, bit fiddly getting to the springclip. Undo the 2 12mm bolts. Remove old dump valve and gasket.
Insert blanking bung into recirc hose and replace springclip (I actually swapped the springclip for a jubilee clip for ease of use). Place new gasket and dump valve in situ. Tighten 12mm bolts. Attach vacuum hose. Job done.
Sorry, I dont have any photos.
Hope this helps.

Mark

donutman

i take it arrived then m8?

scoobyverysoon

iTrader: (1)

here is a picture of mine fitted to a MY 00 its dead easy just as marksWRX says



hope this helps

Jud

CHRIS_D

guys, what colour spring are you using ?

I got a red & a blue with mine. red was squeeky, blue doesnt woosh until high rpm. so i ordered the tuning pack from forge, now have a yellow fitted - wooshes a lot easier.

I had a forge VTA on my my98 with the yellow and it used to chatter a lot more than this one.

chris

forehead

Yep thanks m* - arrived and is now fitted. Thanks

Steve

forehead

Thanks for the advice guys

Steve