Myth or truth!!
#1
Scooby Regular
Thread Starter
Join Date: Feb 2006
Location: Harlow
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Will I need to disconnect my battery for 12hrs to reset my ecu, as I put a tank of normal unleaded in.
Have I lost performance, is it worth doing????
Have I lost performance, is it worth doing????
![Freak3](https://www.scoobynet.com/images/smilies/freak3.gif)
#6
Scooby Regular
Join Date: Sep 2003
Location: No longer Japan !
Posts: 1,742
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Depending on what Impreza you have, there is a procedure which will allow you to reset the ECU in about a minute.
ECU Reset
On early MYs (especially pre MY97) the ECU retards the ignition when knock is detected, however, it is very slow to advance the timing again. An ECU reset will restore the car to factory default settings. This will remove any stored fault codes and restore ignition advance. It is possible to reset the ECU by following these steps:
* Turn ignition OFF
* Connect Read Memory Connectors & Test Mode Connectors
(jumper 5) [black connectors] – (jumper 6) [green connectors]
* Turn ignition ON (engine off)
* Engine Check lamp turns on
* Depress accelerator pedal completely
* Then return it to the half-throttle position and hold it there for two seconds
* Release pedal completely
* Start engine
* Code is indicated by Pulsing lamp
* If a fault is detected - Check ECU Code
* If no fault is detected - drive the car sensible for a couple of minutes
i.e. until warm (do not run tall & do not thrash it!)
* When the ECU has been reset the Check Engine Light will flash
* Code is indicated by Pulsing lamp
* If a fault is detected Check ECU Code
* Turn ignition OFF & Disconnect Connectors
* If there is a fault Check Appropriate Sensor
ECU Reset
On early MYs (especially pre MY97) the ECU retards the ignition when knock is detected, however, it is very slow to advance the timing again. An ECU reset will restore the car to factory default settings. This will remove any stored fault codes and restore ignition advance. It is possible to reset the ECU by following these steps:
* Turn ignition OFF
* Connect Read Memory Connectors & Test Mode Connectors
(jumper 5) [black connectors] – (jumper 6) [green connectors]
* Turn ignition ON (engine off)
* Engine Check lamp turns on
* Depress accelerator pedal completely
* Then return it to the half-throttle position and hold it there for two seconds
* Release pedal completely
* Start engine
* Code is indicated by Pulsing lamp
* If a fault is detected - Check ECU Code
* If no fault is detected - drive the car sensible for a couple of minutes
i.e. until warm (do not run tall & do not thrash it!)
* When the ECU has been reset the Check Engine Light will flash
* Code is indicated by Pulsing lamp
* If a fault is detected Check ECU Code
* Turn ignition OFF & Disconnect Connectors
* If there is a fault Check Appropriate Sensor
#7
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Originally Posted by silverscoobydan
I thought the ecu worked on an average system. Therefore one tank will probably make very little difference overall.
Dan
Dan
Trending Topics
#10
Scooby Regular
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Well, personally, I would get a £500 Re-Map done .... then another when you put your first choice petrol in.
Buy a CockLink and ensure that you have a GEEK with a LapTop and some Spastic Det.Cans.![Roll Eyes (Sarcastic)](https://www.scoobynet.com/images/smilies/rolleyes.gif)
Your pistons will melt if you don't!!
Pete
Buy a CockLink and ensure that you have a GEEK with a LapTop and some Spastic Det.Cans.
![Roll Eyes (Sarcastic)](https://www.scoobynet.com/images/smilies/rolleyes.gif)
Your pistons will melt if you don't!!
Pete
![Wink](https://www.scoobynet.com/images/smilies/wink.gif)
#11
Scooby Regular
Join Date: Jan 2005
Location: In my oven painting yet another new car
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Man you do make me laugh you are one funny ******
![Notworthy](https://www.scoobynet.com/images/smilies/notworthy.gif)
Originally Posted by pslewis
Well, personally, I would get a £500 Re-Map done .... then another when you put your first choice petrol in.
Buy a CockLink and ensure that you have a GEEK with a LapTop and some Spastic Det.Cans.![Roll Eyes (Sarcastic)](https://www.scoobynet.com/images/smilies/rolleyes.gif)
Your pistons will melt if you don't!!
Pete![Wink](https://www.scoobynet.com/images/smilies/wink.gif)
Buy a CockLink and ensure that you have a GEEK with a LapTop and some Spastic Det.Cans.
![Roll Eyes (Sarcastic)](https://www.scoobynet.com/images/smilies/rolleyes.gif)
Your pistons will melt if you don't!!
Pete
![Wink](https://www.scoobynet.com/images/smilies/wink.gif)
#12
Scooby Regular
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Originally Posted by scooby jay
Man you do make me laugh you are one funny ******![Notworthy](https://www.scoobynet.com/images/smilies/notworthy.gif)
![Notworthy](https://www.scoobynet.com/images/smilies/notworthy.gif)
![Wink](https://www.scoobynet.com/images/smilies/wink.gif)
![Wink](https://www.scoobynet.com/images/smilies/wink.gif)
![Big Grin](https://www.scoobynet.com/images/smilies/biggrin.gif)
Pete
Thread
Thread Starter
Forum
Replies
Last Post