Disks/Pads & anti roll bar F+R bushes
#1
Disks/Pads & anti roll bar F+R bushes
Hi all,
Any idea where the best place to purchase some new disks and pads at a resonable cost? Standard 97 Turbo (I think fronts are 277mm vented, rears not sure but solids).
Also where should I get the anti roll bar bushes?
I have yet to look at the way these are attached - are they easy enough to remove and refit?
Any special tools needed for either of the jobs? I have most tools.
Thanks in advance.
Any idea where the best place to purchase some new disks and pads at a resonable cost? Standard 97 Turbo (I think fronts are 277mm vented, rears not sure but solids).
Also where should I get the anti roll bar bushes?
I have yet to look at the way these are attached - are they easy enough to remove and refit?
Any special tools needed for either of the jobs? I have most tools.
Thanks in advance.
#2
If its standard stuff you are after you will struggle to find cheaper than www.camskill.co.uk. Easy site to navigate too.
ARB bushes. You get them free when you buy the Whiteline uprated bar Another place I know stocks whiteline bushes is AWD motorsport in perth. You could get powerflex ones also, or of course standard ones from subaru.
Bushes replaced is dead easy - one bolt, 12mm IIRC, then the holder pivots down. Discs and pads are as you would expect. Nothing special required for either job.
Ritchie
ARB bushes. You get them free when you buy the Whiteline uprated bar Another place I know stocks whiteline bushes is AWD motorsport in perth. You could get powerflex ones also, or of course standard ones from subaru.
Bushes replaced is dead easy - one bolt, 12mm IIRC, then the holder pivots down. Discs and pads are as you would expect. Nothing special required for either job.
Ritchie
Originally Posted by GTTurbo
Hi all,
Any idea where the best place to purchase some new disks and pads at a resonable cost? Standard 97 Turbo (I think fronts are 277mm vented, rears not sure but solids).
Also where should I get the anti roll bar bushes?
I have yet to look at the way these are attached - are they easy enough to remove and refit?
Any special tools needed for either of the jobs? I have most tools.
Thanks in advance.
Any idea where the best place to purchase some new disks and pads at a resonable cost? Standard 97 Turbo (I think fronts are 277mm vented, rears not sure but solids).
Also where should I get the anti roll bar bushes?
I have yet to look at the way these are attached - are they easy enough to remove and refit?
Any special tools needed for either of the jobs? I have most tools.
Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM