how much does a remap cost for a sti version 2 1996 on a n plate

 

if its a standard ecu then it cant be remapped,you will need either a scoobychip,or a piggy back ecu like a unichip or similar.Other option it a complete ecu swap like apexi power fc or Gems etc which isnt a cheap option but is fully remappable

 

how much we talkin for a apexi fc or a gems??

 

Gems are like 1200+ just for the ecu
Apexi is somewhat cheaper, 300? not sure as I dont need one

Tony

 

Apexi purchased and mapped to your car roughly £900....... although can be done cheaper if you can source a unit secondhand....

 

Doesnt Andy Forrest till supply fit and map an A'PEXi for £750? I wouldnt bother with the GEMS; in my opinion theyre more sizzle than sausage. A ScoobyECU-type daughter board might be a reasonable stop-gap too. Mapped-to-suit solutions from ScoobyClinic arent far short of the A'PEXi price (so Id wait a little longer for the PowerFC); but a generic solution from ESL for £200 could be just what youre looking for.

As an aside the 6K has* very very similar ignition and fuel maps to the C1 & C2 series Z4 ECU, which runs very happily on SUL (100RON fuel wasnt commonly available in japan then after all...)

Simon

*Id still confirm this with someone knowledgable like Scott.T though

 

Andy does list that price........ but plus vat and poss travel costs involved also



edited to say just rechecked his site,and i cant see its plus vat...... though i think when i contacted him about one it was mentioned