folding mirror motos, anyone changed one?
#1
folding mirror motors, anyone changed one?
has anyone changed a motor in their side mirrors on the scoob? the motor has gone in my offside mirror, have got a replacement mirror of ebay but its scratched to hell, so would prefer to swap the motors.
anyone?
anyone?
Last edited by Jamo; 11 November 2006 at 02:47 PM.
#2
ok, so no one replied so I decided to do it myself!!!
right so maybe this will help someone??
get the mirror off, make sure you take the door card off, and unclip the wiring connector.
unscrew the three screws, get the mirror on a table turn it upside down, theres 3 screws, just take them out.
the mirror will come apart into 2 pieces.
the fiddley bit, heat the glass up and get a sharp flat head screw driver between the warm plastic and the glass and find the two sticky pads by feeling carefully.
get the glass off, unscrew the plate the glass sits on by taking out the four screws, then theres another four screws holding the motor in place. just take them out and replace the unit, easy.
the hard bit is getting the glass back in (well I didnt manage to do it)
i will
right so maybe this will help someone??
get the mirror off, make sure you take the door card off, and unclip the wiring connector.
unscrew the three screws, get the mirror on a table turn it upside down, theres 3 screws, just take them out.
the mirror will come apart into 2 pieces.
the fiddley bit, heat the glass up and get a sharp flat head screw driver between the warm plastic and the glass and find the two sticky pads by feeling carefully.
get the glass off, unscrew the plate the glass sits on by taking out the four screws, then theres another four screws holding the motor in place. just take them out and replace the unit, easy.
the hard bit is getting the glass back in (well I didnt manage to do it)
i will
Last edited by Jamo; 11 November 2006 at 04:18 PM.
#5
Originally Posted by DazW
As above ...Tyron, your kettle tip worked like a dream!
Just remember when your pouring the boiling water on that it is gonna run out the bottom
#6
yeah,did my motor last month,so nice to have both them folding in now !!
took me agaes to work out the glass actually came away from the plastic surround,just didnt look like it was meant to !
took me agaes to work out the glass actually came away from the plastic surround,just didnt look like it was meant to !
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM