I am changing my clutch in my 95 import and have a problem removing the gearbox. I have removed all the obvious bolts and linkages but when i pull the gearbox back off the bellhousing locating dowels the clutch release bearing arm locks solid and the gearbox will not come back any further than about 20mm .

Is there any additional bolts that I may have missed either through the gearbox itself or above the front crossmember. there is a black cover plate on the bottom of the bellhousing held in place by two 10mm bolts is there any more bolts holding gearbox in place under there

Cheers

 

yes !!!!!




at the side of the starter motor on the bell housing

you will find a 10mm Alan key plug

remove that and

then insert a 6mm bolt to the clutch arm pin pull the pin out

then the box will *** out to

 

beat me to it

As above..


Andy

 

That's the one, thanks

Another few hours and |I should be done, fingers crossed

 

Welldone! Especially if you're doing it on your own!