keeping silicone usable ? ? ?
05 July 2008 | 11:38 AM
#1
Guest
Posts: n/a
keeping silicone usable ? ? ?
mornin all, has anyone got any ideas on how to keep silicone tubes, and tiger seal ( the ones in the trigger action gun thingys ), still usable after using them without the nozzle going completely rock solid?
ive tried the usual, putting screws and bolts in the end but it dont work. any ideas peeps?
dan
ive tried the usual, putting screws and bolts in the end but it dont work. any ideas peeps?
dan
05 July 2008 | 11:54 AM
#2
Nowt, really. You can slow it down by wrapping the nozzle end in clingfilm, but if you leave it long enough, it'll still go "off".
I tend to do as above, then leave a little sticking out INSIDE the clingfilm, so that you can grip it and pull out the "gone off" stuff leaving the nozzle free to use again.
It works if you pull slowly without twisting, and if the stuff isn't hard all ther way up the nozzle.
If that's the case, remove nozzle, check that the stuff in the tube is still usable, them pick out the silicone from the wide end of the nozzle with a small screwdriver and a bit of patience.
Alcazar
I tend to do as above, then leave a little sticking out INSIDE the clingfilm, so that you can grip it and pull out the "gone off" stuff leaving the nozzle free to use again.
It works if you pull slowly without twisting, and if the stuff isn't hard all ther way up the nozzle.
If that's the case, remove nozzle, check that the stuff in the tube is still usable, them pick out the silicone from the wide end of the nozzle with a small screwdriver and a bit of patience.
Alcazar
Thread
Thread Starter
Forum
Replies
Last Post