trying to talk the wife into this , but while i beg what are peoples opinions and how easy to fit

any pics

cheers phil

 

If its a UK version I wouldn't bother, horrible seats !

JDM pre MY05 or Spec C or V7 UK STi, then go for it.

Also on the MY06 the frames are slightly different. They mount about an inch higher IIRC from when I looked into it.

 

I fitted 06 spec c seats in mine mate and it's a pretty easy job, only problems I ran into were the seat belt fasteners needed switched over and there was a 2 inch gap between the rear parcel shelf and top of seats that needed covered so you could not see the yellow foam.

They do sit a bit higher but driving position is fine, passenger seat does seem to sit higher than drivers though.

I would say go for it mate, transforms the inside of the car and I'm very pleased with mine.

 

yes think they are my06 uk

anyone else with any input

is there much different between uk sti and a spec c

 

anyone

 

Would really urge you to try the seats as I found them to be pretty poor. No idea about a Spec C, but standard 06 UK STI seats are too wide and do not hold you in like the Classic MY99/00 seats.

They will also raise your sitting position a little which annoys some people.

I put V7 STI seats in mine as mentioned above and they are great. Much narrower and hold you in properly. There is a problem with needing to sort out the rear seat where there is a gap at the top, but it's a relatively simple job to do.

 

anybody lhave these fitted and like them ?