facelift advice
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Feb 2009
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
have fitted facelift bonnet, headlights and grille.....
however the bonnet scoop inside bit is straight and my tmic is angled, does this matter?
i have the inner peice from my old bonnet but screw holes do not line up the same
however the bonnet scoop inside bit is straight and my tmic is angled, does this matter?
i have the inner peice from my old bonnet but screw holes do not line up the same
#3
Scooby Regular
iTrader: (4)
Join Date: Apr 2009
Location: Making noise in Scotland
Posts: 805
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
Just re-drill the screw holes on your old air vent, or fit a later type intercooler, it will fit the new scoop and be a good upgrade. Did this upgrade on my V2 STI with a V5 STI tmic and it runs so much cooler and is ready for future power upgrades!!
#5
Scooby Regular
iTrader: (4)
Join Date: Apr 2009
Location: Making noise in Scotland
Posts: 805
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.scoobynet.com/images/icons/icon1.gif)
It's a bit of a squeeze and you'll need a set of samco hoses to restore the dump valve position. I had to hammer down the engine mount shroud and take a few mill of the throttle body, but apart from that no worries. I think there's a fitting guide on the forum aswell!!
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM