60mm single gauge pod
07 December 2009 | 08:39 PM
#1
Guest
Posts: n/a
60mm single gauge pod
right here goes. i have just bought a new 60mm defi bf gauge to go with my other three. of which they are in a nice carbon centre pod. i wanted to put my new gauge in an a pillar pod. so i bought one from nomad racing. it arrived today and the quality is cr*p. 
. i wouldnt put it in the boot, let alone the cockpit. it doesnt fit anywhere near. so im now thinking of where else i can mount it.
does anyone have any ideas, links etc on another placement for the gauge. ? .
dan
. i wouldnt put it in the boot, let alone the cockpit. it doesnt fit anywhere near. so im now thinking of where else i can mount it. does anyone have any ideas, links etc on another placement for the gauge. ? .
dan
Last edited by HT04; 07 December 2009 at 09:02 PM.
07 December 2009 | 08:48 PM
#2
How handy are you with fiberglass and filler? id get a spare pillar plastic and mould it in, that should sort the crap quality out and make it look like its meant to be there. Thats what i did with mine on my old honda when i had that problem. Looked nice.
07 December 2009 | 08:59 PM
#3
Guest
Posts: n/a
thats a possibility actually. because the quality of the join (pillar trim and pod), doesnt have to be perfect, because it can be flocked to go with the flocked dash.
but i cant find a single pod anywhere. let alone another a pillar trim
dan
but i cant find a single pod anywhere. let alone another a pillar trim
dan
Last edited by HT04; 07 December 2009 at 09:01 PM.
07 December 2009 | 09:21 PM
#4
Would have to be a breakers i guess for ya pillar to save you buying new, or could use the one on your car if you dont mind it being off for a week or so. You could prob make the whole thing includeing the pod.
My old honda one
My old honda one
Thread
Thread Starter
Forum
Replies
Last Post