tyler120706

Hiya everyone my inlet pipe is split and loosing presure how do u remove them ? I've bought a silicone replacement to go on but apart from the one 12 mm attaching it to the inlet I can't see how else it's held on any help would be great Im car less until I sort this out. Cheers tyler

leecalcars

iTrader: (37)

manifold off if standered inlet pipe fitted

D6ale

iTrader: (1)

As above, you need to remove the inlet manifold in order to replace inlet pipe, it's a good opportunity to install some carldavey inlet spacers too ( which lift the inlet manifold - and can make new inlet easier )

sandyRS16i

iTrader: (13)

If you are installing and aftermarket silicone pipe you dont need to remove the inlet, but the OE pipe you are taking off will end up destroyed which may not be an issue? If you want to refit and OE pipe you need to remove the manifold.

tyler120706

How will I be able to get it out Cos there is no chance of using it again

sandyRS16i

iTrader: (13)

You will need to remove the PS assembly. It will pull out the front then.

tyler120706

many thanks for that guys