fitting STi intercooler to classic
#2
i believe that is what you do, i only fitted a 2003 WRX TMIC to my 95 classic so didnt have this issue,but fitting the STI one,yes,trim the height of the clutch bottle,you could relocate it but this would require more work etc.
for best fit,as i did to mine,trim the depth of the throttle body link pipe,the bit where the 70mm tube connects the TMIC to the throttle body to give that smidge more room,i also trimmed the Y bracket just above the support link rod underneath the TMIC to allow easier fitment and also to stop the rattling/knocking of the TMIC onto this part.
i think each person does an extra bit or doesnt do an extra bit,depends on how finicky you are,i am LOL
good luck
for best fit,as i did to mine,trim the depth of the throttle body link pipe,the bit where the 70mm tube connects the TMIC to the throttle body to give that smidge more room,i also trimmed the Y bracket just above the support link rod underneath the TMIC to allow easier fitment and also to stop the rattling/knocking of the TMIC onto this part.
i think each person does an extra bit or doesnt do an extra bit,depends on how finicky you are,i am LOL
good luck
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
KOEScoob
ScoobyNet General
6
17 September 2015 03:51 PM