guy27687

iTrader: (1)

I have a bailys dump valve (on when bought) and just wondered if I replaced it with a decent aftermarket recirc valve would I need a remap?? I have a simtec ecu if that matters. Thank you

guy27687

iTrader: (1)

And does anyone have one for a v4 type
R

chopperman

If its been mapped with the VTA it will need a map tweak when you go back to re-circ to be safe.

guy27687

iTrader: (1)

Thank you

trails

iTrader: (41)

depends if you are still running the standard MAF or not

guy27687

iTrader: (1)

ohhh god, its in the pile of bits on the garage floor how do i tell its the standard one? there is a three pin connector that goes into it but then further down the pipe there is a very strange sensor thats there too, this this is a two pin

trails

iTrader: (41)

sounds like thats the one...best bet would be to speak to your mapper to confirm though if a remap is required or not

DonNedly

iTrader: (10)

I was advised that it would only want a tweak if it wasn't running right after going back to recirc.