Hi I have taken my back seat up and can't seem too get at it there ? Any ideas what too do?

 

Get at it from the boot or remove the back part of the rear seat.

 

Great thank you I found a square hole and a round hole. I will have a go at fitting the new pump tomorrow

 

Open the boot, the oval shaped cover on the right hand side against the rear seat is where the fuel pump is.
There are 4 screws holding the cover down, remove that and you'll see 3 pipes. Remove the clips and pull the pipes off (have a cloth ready to mop any fuel up).
Then remove the 4 nuts that hold the pump housing down and then remove. Be very careful when removing as it needs a bit of twisting and fiddling to remove without damaging the float.
Once it's out the rest is simple.

 

a DIY guide for u .....

http://www.rexnet.com.au/forum/index...p-installation

 

thank you fellas, i will be attempting this after work tonight! much obliged