JohnD

iTrader: (5)

Having just fitted my FMIC I am in the market for a turbo to replace my MD321H
I need to find the best place, relatively local, to supply, fit and map an MD321T billet. Preferably with rolling road facility.
Present engine spec on my 45k 03 STi includes: 650 inj., full 3" Milltek system, GT spec headers with Harvey S up-pipe, AVC-R

Any recommendations within a sensible distance from Romford would be welcome!

JohnD

Jolly Green Monster

iTrader: (4)

Can sort

Yhpm

L.J.F

iTrader: (31)

Ready to go past 400 now then John? As for a local place, I would say Slowboy Racing near Brandshatch as he would the best specialist nearest to us

JohnD

iTrader: (5)

Was nudging 400 with the top mount so with the FMIC and map tweek would hope it would top that figure on the existing spec. As I'd gone (rather reluctantly) to the front mount, I thought I may as well go to the sensible limit along with the current engine spec. After discussion I thought the MDX321T would be (arguably) the best turbo to give good spool as well as power.
I have considered Slowboy as they also trade the MD turbos but need to be assured as to their mapping expertise. Up to now, the car has been mapped by a very well known and respected person in this field but I'm having a few problems in getting organised with him at the moment!

JohnD

JohnD

iTrader: (5)

Simon
Read you PM and will reply later with a few questions, if that's OK?
Cheers JohnD

New_scooby_04

iTrader: (4)

Extreme Scoobies in Boreham Esex, give Paul a ring.

frayz

iTrader: (7)

Simon JGM and Charlie @ Surrey Rolling Road

JohnD

iTrader: (5)

I usually get Paul to do the bits I can't get to safely (I've no personal access to a lift.) He could fit the turbo fine, but would need to organise a mapper!

JohnD

JohnD

iTrader: (5)

Frayz
Would Surrey Rolling Road be able to do the turbo swap?
Sounds favorite at the mo. as it's easy to get to, amongst other things!

JohnD

frayz

iTrader: (7)

Possibly mate. Ask Simon

frayz

iTrader: (7)

Unless you swap the turbo and leave the actuator rod off to drive to SRR?

Jolly Green Monster

iTrader: (4)

replied

kent-scooby

I keep seeing Simon's work on facebook ie dyno printouts he is a highly recommended i would take the time and drive over and see him im saving up my hard aren't money at the moment and will be arranging to have my car mapped by him in the near future

cster

From my experience, I would go JGM/rolling road or Slowboy from the above options.