Classic bits - fog light covers, door cards, exhaust, lightweight pulley, etc.
#1
Classic bits - fog light covers, door cards, exhaust, lightweight pulley, etc.
Having a bit of a clearout because I'm leaving the country. Items located in Cambridgeshire (CB21) but can be brought down to SW London/Richmond area.
Prices include postage (unless stated) but not PP fees.
Fairly unsure on what these bits are worth, so please let me know if I've wildly over-priced anything!
Lightweight pulley - never fitted - couple of marks from storage but mainly just dusty - SOLD
GC8 door cards - quite a few small indentations and a couple of scuffs, but all the white marks come off easily (was in a rush to photograph them!). All switches present as per photos - £30 posted (£20 collected)
Fibreglass (I assume?) fog light blanking covers. Unpainted and undrilled; as per photos - £15 posted
Air filter and filter-to-MAF bracket with rubber seal and jubilee clip. Both used for 100 miles, if that. (iPhone plug for scale!) £14 posted
Standard V1 WRX downpipe with catalytic converter and lambda (unsure if lambda is functioning - never been on the car since I've owned it) - £65 (£75 posted)
Standard V1 WRX mid section with 3" flange to accept 3" downpipe - a bit rusty - £15 collected (£25 posted)
Thanks!
Prices include postage (unless stated) but not PP fees.
Fairly unsure on what these bits are worth, so please let me know if I've wildly over-priced anything!
Lightweight pulley - never fitted - couple of marks from storage but mainly just dusty - SOLD
GC8 door cards - quite a few small indentations and a couple of scuffs, but all the white marks come off easily (was in a rush to photograph them!). All switches present as per photos - £30 posted (£20 collected)
Fibreglass (I assume?) fog light blanking covers. Unpainted and undrilled; as per photos - £15 posted
Air filter and filter-to-MAF bracket with rubber seal and jubilee clip. Both used for 100 miles, if that. (iPhone plug for scale!) £14 posted
Standard V1 WRX downpipe with catalytic converter and lambda (unsure if lambda is functioning - never been on the car since I've owned it) - £65 (£75 posted)
Standard V1 WRX mid section with 3" flange to accept 3" downpipe - a bit rusty - £15 collected (£25 posted)
Thanks!
Last edited by HarryB; 08 August 2018 at 01:49 PM.
#3
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
RS_Matt
General Technical
4
14 November 2014 03:23 PM
ScoobyForLife27
General Technical
11
28 December 2010 05:53 PM
trickywickywoo
General Technical
18
02 November 2006 06:11 PM