CDB engine
#1
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Aug 2007
Location: bexhill east sussex
Posts: 1,342
Likes: 0
Received 0 Likes
on
0 Posts
CDB engine 400 quid ono alloy wishbones ss exhaust etc
Hi there i will have a CDB engine all running it'll be a long engine inc inlet manifold flywheel etc it was rebuilt in 2008 with reciepts for new Crank comitec headgasket new oil pump etc also have pictures.there are no rattles knocking smoking etc even from cold I'm looking for 400 quid
Also equal length headers are available 50 quid
Alloy arms 85
Ss cat back one piece exhaust 50
Wrx servo and marster cylinder non abs 40 quid
Clutch marster and slave cylinders 40 quid still connected
Non abs hubs 20 quid each
Rear no plate bulb holders good but used 30 quid
Wrx gear box and diff 100 quid
And more!!
Plus postage
The engine is still in the car so can be heard from cold.
Cheers
Also equal length headers are available 50 quid
Alloy arms 85
Ss cat back one piece exhaust 50
Wrx servo and marster cylinder non abs 40 quid
Clutch marster and slave cylinders 40 quid still connected
Non abs hubs 20 quid each
Rear no plate bulb holders good but used 30 quid
Wrx gear box and diff 100 quid
And more!!
Plus postage
The engine is still in the car so can be heard from cold.
Cheers
Last edited by jonnyricer2; 26 July 2015 at 12:09 PM.
Trending Topics
#18
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Aug 2007
Location: bexhill east sussex
Posts: 1,342
Likes: 0
Received 0 Likes
on
0 Posts
Details of the engine are above. As in rebuilt 2008 don't know the milage about 40 k suspect standard rebuild with new Crank rods pistons oil pump purchased from graham goode racing and Cheam subaru
No knocking from the bottom end no smoke etc
No knocking from the bottom end no smoke etc
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM