Camber issue
#1
Scooby Regular
Thread Starter
Join Date: Nov 2004
Location: Cambridgeshire
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
Camber issue
was at Elite yesterday to get the geometry checked & set up on the scoob... MY06 STi. It was , although within tollerence a bit out....so decided to set it as my old one to the Prodrive settings..... big problem.....
..... the camber bolts would only allow a max of -30' each side not the -1.15' I had before.....pants!! anyone know if this typical on the JDM or just someting particular to mine??
Would have thought that the only diff on JDM to UK if anything would be the damper / spring rate.... anyone know?
Also can anyone advise if there are any lowering springs that suit this car? Do Prodrive do MY06 springs and wold they fit the JDM?
..... the camber bolts would only allow a max of -30' each side not the -1.15' I had before.....pants!! anyone know if this typical on the JDM or just someting particular to mine??
Would have thought that the only diff on JDM to UK if anything would be the damper / spring rate.... anyone know?
Also can anyone advise if there are any lowering springs that suit this car? Do Prodrive do MY06 springs and wold they fit the JDM?
#2
Scooby Regular
Join Date: Jul 2000
Location: Solihull
Posts: 1,498
Likes: 0
Received 0 Likes
on
0 Posts
That's fairly typical for the later cars, you'll not get to anywhere near 1 deg neg at std rideheight. Our spring kit fits all 06MY STi and you should get much nearer the 1 deg at the rideheight they give.
Mike
Mike
#3
Scooby Regular
Thread Starter
Join Date: Nov 2004
Location: Cambridgeshire
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for that Mike. Spoke to dealer today he tells me that there's nothing listed for the MY06 prodrive springs....are they the same as the '04 / '05 ones?
Thanks
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Phil3822
General Technical
0
30 September 2015 06:29 PM