I do not know what you call them, but i need the 2 cilinder heads of the block. With the valve in it.It must be STI III (1998) and have to be in good condition.

Can someone help me?
You can email to: cheungmikesharon@hotmail.com

Regards Mike

[Edited by Mike555 - 12/9/2003 8:25:50 AM]

 

up

 

Mike,

My car has just gone into Scoobyclinic with a subsequent engine failure - I think it may be a piston. The bottom end is supposedly STi Version III (as fitted by Central Subaru).

I know this info is not much use to you right know, but depending on what way we decided to go with the repair (potential 2.5 block) I guess the heads could be available. I would like to get confirmation that they are STi III as advised by Central.

If they are what you're looking for and are available, I'll let you know (hopefully by the end of this week).

Kevin

 

Thanks Kevin,

I will wait for it.

Regards Mike

 

No probs... just been reading a thread on 2.5 ltr conversions - they may retain the heads & also cost of converting 2.5 could be a major factor, so we'll see what The Gaffer (and others) advise is my best and most cost effective option.

Cheers,

Kev

 

Mike555,

Bad news I'm afraid - it appears the engine fitted to my car was an extremely poorly built standard engine not STi ver III as advised. So no heads I'm afraid - sorry to get your hopes up. I just need to sort this mess out now.

Kev

 

No problem Kev,

Hope you will have your car fixed up soon.

Mike

 

Thanks Mike,

We now have an STi II RA lined up to go in over the next couple of weeks - that should be fun, especially once mapped. I'll keep an ear to the ground for STi heads for ya!

Kev

 

Maybe someone knows where to buy?/

Mike

 

I'm collecting my car today (just 7 days after taking it in). I will try to remember to ask if they have any STi heads there or know the best place to source them.

Kev