I have a dv tiwn port as below, and need a few parts.

Need a bung to block of rear port

Also need adaptor to fit to pipe

PLease put up what you have thanks

 

bttt

 

bttt

 

bttt

 

bttt

 

bttt

 

bttt

 

i work as a manual/cnc turner miller ,so could make you the bung and dedendant on how involved it was,could also make you the adaptor plate

i have made a few bov/re circ adaptor/bungs/blanking plates all out of aluminium for my local club members and was unsure about if i could sell them on here
PM me with sizes etc mate if interested and can send you pictures of these,just need your email address
Neil

 

Nice one, you should do group buy.

 

Good idea mate,
I make these and other bits around my full time job
So batches of 3 or 4 are easier to produce
One offs and little turning jobs are fine
Neil

 

Well if cheap enough might buy 3 or 4. On'y problem is i don't have a blanking plug to give you measurements. Also do have a port so can mesure that as that bit need blanking

 

Pm sent

 

pm replied

 

Did your measure the port that needs a blanking plug? Or have you done me a small sketch of what you wanted making mate?
I'm back to work Tuesday , so could do them tues/wed if you wanted